![]() ![]() Remember that normally the bootloader modifications are made using patches. Unsigned int bytes_per_pixel /* 3:RGB, 4:RGBA */ * GIMP RGB C-Source image dump (image.c) */ The form of the image-file must be similar to: $DEVDIR/bootloader/uboot.*/src/include/configs ![]() Use the following configuration to set the splash screen position to the center of the screen: Colibri iMX7 setenv splashpos m,m. Support U-Boot splash screen to kernel in imx8MP f. ![]() The same steps can be applied to other bootloaders and operating systems. To set the logo position to x pixels and y lines: setenv splashpos ,. The steps in this document are demonstrated using U-Boot and Linux kernel.The CONFIG_SPLASH_LOGO_FILE configuration setting can be found in the Splash Screen section in your board file in the directory It is possible to adjust the position of the splash screen on the display by setting the splashpos variable. $DEVDIR/bootloader/uboot.*/src/board/davinci/commonħ- Change the variable value CONFIG_SPLASH_LOGO_FILE with the name of file used above. 1 GRUBAdding a splash screen to boot on Arch Linux installation. To have u-boot load kernel image, set in your nf. If you want Linux to keep your U-Boot Logo during boot process, then some tweaks are. 1- Get image that you want to show in resolution smaller than your display resolution.Ģ- Open the image using GIMP graphic application.ģ- Save the image using "save as" option.Ĥ- In the select box "Select File Type (by Extension)" select the format "c source code"ĥ- Then you will get one windows with some options, in this window deselect all options (Use glibs types, use macros instead of struct, Use 1 byte run-length-encoding, Save alpha channel)Ħ- Then save this file (changing the file extension from. By default a rainbow splash screen is shown after the GPU firmware is loaded. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |